Co robi ROUTE użycie. Konsola two commands: add , to add a route, and del , to delete a route. The.

Czy przydatne?

Polecenie route

Wykonanie, użycie: TCP/IP command. Add or remove entries in the routing tables maintained by routed. route accepts two commands: add, to add a route, and del, to delete a route. The two commands have the following syntax:

add [-net | -host] address [modifiers] del [-net | -host] address [modifiers]

address is treated as a plain route, unless -net is specified or address is found in /etc/networks. -host can be used to specify that address is a plain route whether or not it is found in /etc/networks. Using route modifiers, you can specify the gateway through which to route packets headed for that address, its netmask, TCP mss, or the device with which to associate the route; you can also mask certain routes. Only a privileged user may modify the routing tables.

If no command is specified, route prints the routing tables

Opcje wykonania route w konsoli

-A family, --family

Specify an address family to use with an add or del command. family may be inet, inet6, ax25, netrom, ipx, ddp, or x25.

-C, --cache

Perform command on the routing cache instead of the forwarding information base (FIB) routing table.

-e, --extend

Use netstat -r format to print routing table. Use twice to print extended information. Same as netstat -ree.

-F, --fib

Perform command on the forwarding information base (FIB) routing table. This is the default behavior.

-h, --help

Print help message, then exit.

-n, --numeric

Show numerical addresses; do not look up hostnames. (Useful if DNS is not functioning properly.)

-v, --verbose

Verbose mode.

-V, --version

Print version and configuration options, then exit.

Przykłady route działanie w Słownik polecenie R

Przykład ROUTE użycie :
Jak użyć Reverse the order of characters on each line of the specified file and print the results on standard output. If no file is specified, rev reads from standard input co znaczy.
Przykład ROUTE użycie :
Jak użyć administration command. Close out filesystems, shut down the system, then reboot. Because this command immediately stops all processes, it should be run only in single-user mode. If the system is not krzyżówka.
Przykład ROUTE użycie :
Jak użyć Remote shell server for programs such as rcmd and rcp , which need to execute a noninteractive shell on remote machines. rshd is started by inetd and must have an entry in inetd 's configuration co to jest.
Przykład ROUTE użycie :
Jak użyć Network routing daemon. routed is invoked by a privileged user at boot time to manage the Internet routing tables. The routing daemon uses a variant of the Xerox NS Routing Information Protocol in słownik.
Przykład ROUTE użycie :
Jak użyć System administration command. Start the rdist server. Note that you must specify the -S option unless you are simply querying for version information with -V czym jest.